Creating a lace front wig is a long, meticulous process that can take several hours to several days. Once the wig is complete, the excess lace that hangs over the forehead must be trimmed back into the wig for the most natural look. This is a delicate process that takes a steady hand, a good pair of scissors and a lot of patience. Since a lace front wig does not reach all the way around to the nape of the neck, this process will be shorter and a little easier than a full wig.
1.Find the center of the front of the lace wig and slide the thin hair clip vertically to mark the position. There should be two even lace pieces on each side of the clip.
2. Clip the hair on either side of the center-marking clip back using the two large hair clips. This will keep any stray hairs from being cut.
3. Cut away about a quarter-inch of the lace all around the front and sides of the wig. Do this using long, fluid scissor strokes to avoid jagged edges. It is best to cut away small portions of lace instead of all of it at once, since cutting away too much lace will ruin the wig.
4. Remove the center-marking clip. Keep the hair clipped back, adjusting the clips as necessary.
5. Cut the lace back towards the beginning of the hairline in the front. The lace that is on the forehead will be the most visible, so it should be cut back all the way to the hairline. Pull the lace tight with your fingers while cutting to ensure even, smooth strokes.
6. Trim the sides of the lace front wig so that only about an eighth-inch of lace protrudes out from under the hairline. It is not necessary to cut the lace all the way back on the sides, since this part is not as visible as the forehead area.
7. Double check the trimmed lace to ensure that there are no jagged edges. Make sure the lace is cut completely even, especially around the forehead area.
The excess lace is your what is known as “Your box is your guarantee’. Should your new wig not have the excess lace on, please do not accept it as it might not be new. You are only to cut off the extra lace once you have made sure the the unit fits your head perfectly and that there are no bald patches and tears in your unit. Only whilst it still has the lace on can it be returned. You cut off the excess lace as close to the hairline as possible taking effort not to cut off any of the babyhairs, if you get one or two that is fine, but be very careful.